Skip to main content

Garage Construction Cost Calculator

Estimate what a garage costs to build in Australia by floor area, structure type, door and electrical connection. Free, no sign-up.

For a single-car garage of 18 m² of usable internal floor area, the total cost is the floor area multiplied by the installed rate for the chosen structure, plus the garage door and the electrical connection, which are priced separately. The floor area sets the scale, but three factors move the final quote more than the square metres do: the type of construction, the site conditions and the finish level.

The rate per m² depends mainly on how the garage is built. A prefabricated steel garage, with a galvanised frame and metal roof sheeting on a concrete slab, is usually the least expensive option and can be erected in a few days once the slab is ready. A brick veneer or double brick garage is the most common choice for a permanent building: masonry walls, a concrete slab and a tiled or sheeted roof, built on site over several weeks. An attached garage built as an extension of the house costs the most per m², because it has to tie into the existing footings and roof and match the existing walls and finishes.

Some costs do not scale with area. A manual tilt door is the cheapest option, while an automatic sectional door adds a motor, remote controls and a higher installation charge. The electrical connection depends on how far the garage is from the switchboard and whether you want power points for tools or an electric vehicle charger. Sites with a slope, reactive clay or poor access need more excavation and footing work, which can add substantially to the structure cost. Reactive clay in particular calls for footings designed to AS 2870, so check the site classification before comparing quotes.

This calculator does not supply market prices. The per m² rate, the door cost and the electrical cost are inputs you set from written quotes, so the result is only as good as the quotes you enter. Use it to see how the structure type, the size and the extras change the total, then compare builders on a like-for-like scope.

The result updates automatically.

1 car: 151–194 sq ft (about 14–18 m²) · 2 cars: 269–388 sq ft (about 25–36 m²) · With storage: 323–538 sq ft (about 30–50 m²)

Garage sizes are quoted as usable internal floor area in square metres, with dimensions in metres. Structural and wiring requirements come from the National Construction Code, AS/NZS 3000 and AS 2870, with variations adopted by each state and territory. Approval routes depend on the local council and planning controls. Installed rates differ between capital cities and regional areas, so enter the rate from written quotes for your own suburb.

Includes the door, motor and installation. Adjust to match the actual quote.

Lighting circuit, sockets and partial consumer unit work.

Estimated total cost

~$11,600

For 20 · $580 total

Building work
$9,500
Door
$1,500
Electrics
$600
Cost per unit area (estimate)
$580/m²

Turn this calculation into a quote for your client

We're building a tool for professionals. Be among the first to try it.

Share

How it works

1

Select the garage type: prefabricated steel, brick veneer or double brick, or attached extension to the house.

2

Enter the usable internal floor area in square metres (one car: about 14 to 18 m²; two cars: about 25 to 36 m²).

3

Choose the door option: no door, manual tilt door or automatic sectional door.

Formula

C_total = (A × price/m²) + C_door + C_electrical
A — Usable internal floor area of the garage (m²)
price/m² — Installed cost per m² for the construction type: prefabricated steel, brick veneer or double brick, or attached extension; editable value in the calculator field
C_door — Cost of the garage door: manual tilt door, automatic sectional door or no door; editable value according to the door type and finish level
C_electrical — Cost of the basic electrical connection (lighting and power points); 0 if not included

How the calculation works

How much does it cost to build a garage in Australia?

A garage is one of the most variable projects in residential construction. Two quotes for the same 18 m² garage can differ widely, because builders price different scopes, site conditions and finishes. This calculator separates the cost into the parts that scale with floor area and the parts that do not, so you can see where the money goes and test scenarios before you ask for quotes.

The calculator works in metric units. Floor area is entered in square metres, and the per m² rate is the installed cost of the structure, meaning the slab, walls, roof and basic exterior finish. It is not the price of the materials alone, and it is not a labour-only rate.

The three garage types

Prefabricated steel garages are the fastest and least expensive option on a clear, level site. The frame arrives as a kit, is bolted together on a concrete slab and can be erected in a few days. The result is functional and suits sheds and workshops well, but its appearance is utilitarian, so it blends less well with a period or heritage home.

Brick veneer and double brick garages are the standard choice for a permanent garage. Brick veneer uses a timber or steel frame clad in brick, while double brick uses two leaves of masonry. Both sit on a concrete slab, usually have a tiled or metal roof, and take several weeks to build because the masonry, roof and fixings are completed in stages. Costs in the major capital cities tend to be higher than in regional centres, so the rate you enter should reflect your own suburb and the access conditions on your block.

Attached garages built as an extension of an existing house have the highest cost per m². The new structure has to tie into the existing footings, extend or share the roof line, match the wall finish and connect to the house's drainage and electrical systems. Approval is also more involved, because the new work has to be coordinated with the existing house.

What the rate covers and what it does not

The per m² rate normally covers the slab, the wall system, the roof and the basic exterior finish. It normally does not cover the garage door, the electrical work, driveway paving, guttering, site preparation beyond the slab, or council and certifier fees. Many builders quote the structure and leave the rest as provisional or separate items, so ask for an itemised quote that shows each element. A low headline rate with a long list of exclusions does not make a cheaper garage.

The garage door

A manual tilt door is the least expensive option and needs no motor or power connection. An automatic sectional door is the most practical choice for daily use, especially in wet weather, but it adds a motor, safety sensors, remote controls and an installation charge. If power cuts are common where you live, choose a motor with battery backup. Door suppliers and installers quote their own scope, so compare their inclusions against the provisional sum in the builder's quote rather than assuming they match.

The electrical connection

A basic connection covers one circuit for lighting and power points. The cost depends mainly on the distance to the switchboard, the number of points and whether a new sub-circuit is needed. The work must be carried out by a licensed electrician and comply with AS/NZS 3000, the Wiring Rules. If you plan to charge an electric vehicle, allow for a dedicated circuit and check that the switchboard has the capacity for the charger before you commit. Enter zero in the electrical field if the connection is excluded from the calculation or already included in another line of the quote.

Approvals and licensing

Most garages need approval before construction starts. Approval is issued by your local council or by a registered building certifier. The technical requirements come from the National Construction Code, where Volume Two covers houses and Class 10 buildings such as garages, together with the variations adopted by each state and territory and your local planning controls. Some small outbuildings are exempt from approval, but the size and height thresholds differ between states and territories, and boundary setbacks or heritage controls can still apply. Confirm the requirements with your council or certifier before you start, because a garage built without the required approval can cause problems when you sell the property.

Builders and electricians must hold a licence issued by the state or territory regulator. Most regulators publish a searchable register, so check the licence number and any disciplinary history before you sign a contract.

Edge cases in the calculation

If the floor area is zero, the per m² term drops out and the total equals the door cost plus the electrical cost. The total is zero only when both of those are also zero, so a zero area with a door or electrical cost entered still gives a non-zero result. If the per m² rate is zero, only the door and electrical costs remain, which is useful when the structure is already built and you only need to price the add-ons. If the door option is set to no door and the electrical field is zero, the total reflects the structure alone. Negative values have no physical meaning for a garage and should not be entered.

When to use this calculator

Use it at the planning stage to compare the three construction types, to see how size and extras change the total, and to check whether a quote falls within a plausible range. It is also useful when you need to explain budget options to other people involved in the decision, such as a partner or a lender.

When not to rely on it

Do not treat the result as a final budget. The calculator does not account for site inspection findings, soil test results, bushfire-prone area requirements under AS 3959, flood controls, heritage restrictions, or the cost of demolishing or removing an existing shed. For an attached garage, or any structure with long spans, heavy roofing or retaining walls, a structural engineer should check the design. Where the garage is large or its shape is unusual, the rate per m² is unlikely to be representative, so get a detailed quote instead.

Common mistakes

The most frequent error is comparing quotes with different scopes. One quote may include the slab and the door, while another leaves both out, and the lower total is not the better deal. A second common mistake is using the structure rate alone and forgetting the door, the electrical work and the approvals. A third is sizing the garage at the bare minimum. A single car needs room to open the doors and walk around the vehicle, so 14 m² can feel tight in practice.

Site conditions are often underestimated. A sloping block, reactive clay or a difficult access route can change the footing and excavation costs considerably, and these are easy to miss when only the floor area is compared. A fair comparison starts with a fixed scope: ask each builder for the same floor area, the same door type, the same electrical allowance and the same exclusions, and keep every quote in writing.

Effect on property value

A garage can add appeal to a home, particularly in suburbs where street parking is limited. The effect on resale value depends on local market conditions, the quality of the build and whether the work was approved. Ask a local real estate agent for their view on the likely effect in your suburb, rather than assuming a fixed uplift.

When to bring in a professional

For a small prefabricated garage, a competent DIYer may be able to handle the assembly by following the manufacturer's instructions, provided the slab is level and the work is approved. For anything involving a concrete slab, masonry, roofing, footings or electrical work, engage a licensed builder and a licensed electrician. An attached garage usually also needs drawings prepared by a building designer or architect and approved before work starts.

Get at least two or three written quotes, check each licence on the regulator's register, ask for references from recent jobs, and read the payment schedule and completion date in the contract before you sign.

Frequently asked questions

How much does it cost to build a garage in Australia?

The cost depends mainly on the construction type. A prefabricated steel garage is usually the least expensive option on a level site, brick veneer or double brick costs more for the same floor area, and an attached garage built as an extension of the house costs the most. The door and the electrical connection are priced separately because they do not scale with area. Use the calculator with the per m² rate and the extras from your written quotes, and check that each quote covers the same scope, including the slab, the door and the approvals.

Do I need council approval to build a garage in Australia?

Most garages do need approval before construction starts. Small outbuildings can be exempt, but the size and height thresholds differ between states and territories, and planning controls such as boundary setbacks still apply. Approval is issued by your local council or by a registered building certifier. Check the requirements with your council or certifier before you sign a contract, because a garage built without the required approval can cause problems when you sell the property.

What is the cost difference between a steel and a brick garage?

For the same floor area, a prefabricated steel garage is usually less expensive than a brick veneer or double brick garage. The difference reflects the build method. A steel kit is bolted together on a prepared slab in a few days, while masonry is built on site in stages over several weeks. Brick suits a permanent home, while steel is more common for sheds and workshops. The calculator shows the relative difference between the types for the area you enter.

What size garage do I need for one or two cars?

A single car usually needs a usable internal floor area of about 14 to 18 m², and 16 to 18 m² gives more room to open the doors and walk around the vehicle. For two cars, about 25 to 36 m² is practical, and 30 to 36 m² is more comfortable. If you want space for storage or a workbench, add roughly 8 to 15 m². Your block size and local planning controls can set limits, so check them with your council before you settle on a size.

Is an automatic sectional door worth it for a new garage?

For daily use, an automatic sectional door is the most practical option because you do not have to get out of the car in wet weather. The extra cost over a manual tilt door covers the motor, the controls and the installation. If power cuts are common in your area, choose a model with battery backup, and ask the installer to confirm the safety features before the work is signed off. The calculator's door field lets you compare the three options at the same floor area.

When should I hire a licensed builder instead of building the garage myself?

A small prefabricated garage can be assembled by a competent DIYer following the manufacturer's instructions, provided the slab is level and the work is approved. For a concrete slab, masonry walls, roofing, footings or any electrical work, hire a licensed builder and a licensed electrician. An attached garage usually also needs approved drawings from a building designer or architect. Get at least two or three written quotes, verify each licence on the state or territory register, and check references before you sign.

Related calculators

View all Garden, Outdoor & Water calculators →

By RivoCalc · Reviewed under our editorial methodology · Updated 13 June 2026

This calculator gives an indicative estimate only. Real costs vary with site conditions, soil, slope and access, the finish level, council and certifier requirements, and each builder's pricing. Confirm the scope and the total in writing with licensed builders and electricians before you commit.