Monthly Water Consumption Calculator for Singapore Homes
Estimates monthly household water consumption in m³ and the cost of the bill, based on household size and usage habits.
A household of four people, each using 140 litres of water a day, uses 16.8 m³ a month, or about 202 m³ a year. For two people on a low-usage profile of 80 litres a day, the monthly total is 4.8 m³. A garden watered regularly adds about 3 m³ a month on top of that during dry spells.
Those figures come from one simple rule: litres per person per day, multiplied by the number of people and by 30 days, then divided by 1,000 to convert litres into cubic metres. The calculator adds the garden and pool allowances to that domestic total, then multiplies the full volume by the water rate you enter to estimate the variable cost of the bill.
For a household, the practical question is how much water the home uses each month and where most of that water goes. Knowing the answer makes it easier to spot a change in the bill before it becomes a surprise.
The calculator suits three common situations. A family in a 4-room HDB flat in Tampines can enter its residents and a usage profile and see the monthly volume. A couple in a condominium in Bukit Timah who want to test whether lower habits would make a difference can switch between profiles. A household in a landed house in Bishan with a garden can add the garden allowance and see how much it changes the total. The same logic applies to any home, as long as the residents and the rate are correct.
Treat the result as a planning estimate, not as a bill. Actual use depends on appliances, fittings, habits and weather, and the bill may include fixed or separate charges that the calculator does not count. Use the calculator to understand what drives your total, then check your PUB bill for the official figures.
The result updates automatically.
Count everyone who lives at the property permanently.
Economical: ~80 L/day/person · Average: ~140 L/day/person · High: ~200 L/day/person.
Estimate for watering from June to September. In winter, select no watering.
Swimming pool
Estimate for evaporation and filter backwashing for a typical domestic pool (40–60 m³).
The water rate per cubic metre is shown on your bill. Use the rate from your most recent bill, since tariffs can change. Consumption values on this page are planning figures for the calculator's three usage profiles, not measured averages for Singapore households.
Estimated monthly usage
equivalent to 420
Estimated monthly cost
estimated annual cost: $151.20
- Household usage
- 12.6 m³/month
- Total
- 12.6 m³/month
- Monthly cost
- $12.60
- Annual cost (excluding standing charge)
- $151.20
How it works
Formula
How the calculation works
Monthly water consumption: what sits behind the bill
Water is one of the few household costs that most people never look at in detail. The bill arrives as a single figure, and it is only when that figure jumps that anyone asks where the water went. This calculator breaks the monthly total into its parts so you can see which of them matters for your home.
It works from three inputs: the number of residents, a litres-per-person usage profile, and two optional extras, garden watering and a swimming pool. It converts the total into cubic metres and multiplies that volume by the water rate you enter. Every step is visible in the formula, so you can check any result by hand.
Typical monthly consumption by household size
The table below uses the same formula as the calculator. Each value is the number of people, multiplied by the litres per person per day, multiplied by 30 days, and divided by 1,000.
| Household | Economical (80 L) | Average (140 L) | High (200 L) |
|---|---|---|---|
| 1 person | 2.4 m³ | 4.2 m³ | 6.0 m³ |
| 2 people | 4.8 m³ | 8.4 m³ | 12.0 m³ |
| 3 people | 7.2 m³ | 12.6 m³ | 18.0 m³ |
| 4 people | 9.6 m³ | 16.8 m³ | 24.0 m³ |
| 5 people | 12.0 m³ | 21.0 m³ | 30.0 m³ |
These are reference values for the calculator's three profiles. They are not measured averages for Singapore households, so your own meter readings are the better basis for a final check.
The economical profile of 80 litres per person per day suits a household that already takes short showers, uses a dual-flush toilet, runs the washing machine only on full loads and fixes leaks quickly. The average profile of 140 litres is the default midpoint. The high profile of 200 litres fits frequent long showers, bathing in a full tub, young children who need frequent washing, or a household that has not yet looked closely at its habits.
How the domestic term is built
The domestic part of the formula, C_dom, stands for everyday uses: showers, toilet flushes, kitchen taps, washing machine cycles, dishwashing and cleaning. The calculator does not model each activity separately. It assumes a single litres-per-person figure that averages those activities across a typical day. This keeps the input simple, but it also means the result is only as good as the profile you choose.
Multiplying by 30 assumes a 30-day month. In a 31-day month the true volume is about 3% higher, so the estimate runs slightly low for that month. Dividing by 1,000 converts litres into cubic metres, because 1 m³ is 1,000 litres. Mixing these two units is the most common arithmetic error when people check the calculator by hand, and it produces results that are off by a factor of a thousand.
How the garden and pool allowances work
The garden term, C_garden, adds a fixed monthly allowance of 0, 1 or 3 m³, depending on the size and watering pattern selected. A small garden watered occasionally by hand adds little. A larger garden watered with a sprinkler on several days a week can add the full 3 m³ allowance. These preset values are planning assumptions, not measurements, so compare the total with your bills over a few months and judge whether the selected option fits.
The pool term, C_pool, adds a fixed 5 m³ per month when a pool is present. This is a conservative allowance for evaporation, splashing and filter backwashing. Actual use depends on pool size, whether the pool is covered, how often it is topped up and the weather. A covered pool that is rarely used will use far less, while an open pool in hot, dry weather can use more.
Singapore's rainfall is generally high, so garden watering is usually needed less often than in drier climates. Dry spells still occur, however, and the garden allowance is meant for those periods as well as for regular watering.
Converting the total into a cost
The total volume is multiplied by the price p, which is the water rate per cubic metre shown on your bill. Rates can change over time, so use the rate on your most recent bill, because it is the rate that applies to your account. An old rate will produce an outdated cost.
Bills often include other items, such as fixed or separate charges, that this calculator does not include. To estimate the full amount payable, add those charges from your bill to the variable cost the calculator shows. Leaving them out is the most likely reason a calculated figure differs from the bill, even when the volume is right.
Common mistakes
The most frequent error is underestimating the garden and pool effect. Neither shows up in everyday use, yet a pool or a regularly watered lawn can add a noticeable share to the monthly total. If the calculator result is well below the bill, check these two settings first.
The second error is ignoring leaks. A dripping tap wastes water every day, and a running toilet cistern can waste far more than a tap, often without any visible sign. The check is simple: turn off every tap and appliance, note the meter reading, wait 30 minutes without using water, and read the meter again. If the reading has moved, there is a leak somewhere in the system.
The third error is counting residents who are not at home. Enter the people who live in the home for most of the month. Occasional visitors are better handled by choosing a slightly higher profile for the months when they stay.
The fourth error is mixing up litres and cubic metres. The calculator works in cubic metres, while many appliance specifications and household notes use litres. Convert before entering any figure by hand, and remember that the monthly total is a volume, not a daily rate.
Edge cases
If the number of people is zero, the domestic term is zero and the calculator returns only the garden and pool allowances. A zero garden or pool setting adds nothing to the total. A zero rate gives a zero cost, which is useful for seeing the volume on its own, but it is not a real billing situation. Negative values have no physical meaning in this calculation, so every input should be zero or positive.
A household that changes size during the year should not apply one figure to the whole year. Work out the number of months for each household size, calculate the monthly volume for each period, multiply each by its months, and add the results together. This weighted approach gives a far more realistic annual total than a single average.
When to use this calculator, and when not to
Use the calculator for planning and budgeting. It shows how a change in habits, a new garden or a new pool would affect the monthly total, and it helps you judge whether a bill falls within a reasonable range. It is also useful before a purchase, since the estimate shows how an extra resident, a larger garden or a pool could change running costs over the year.
Do not use it to dispute a bill. For that, the meter reading and the bill issued by PUB are the authoritative records. Nor is it suited to a building where one meter serves several units and the cost is shared out, because the calculator assumes the household pays only for its own consumption.
When to contact PUB or a licensed plumber
If the bill rises noticeably without a clear reason, such as an extra resident, a new garden, a new pool or an unusually long dry spell, begin by checking for leaks using the test described above. If the meter still moves with every tap and appliance switched off, contact PUB to confirm the meter reading and ask about an inspection. If the leak is in the pipework inside the home, a licensed plumber can locate and repair it. Which parts of the pipework are yours to maintain is a point to confirm with PUB before arranging any work.
Limits of this estimate
The calculator uses one usage profile for the whole household, one garden preset and one pool preset. It does not model individual appliances, the length of each shower, rainwater collection, water recycling or changes in the weather. For a more precise forecast, compare the calculator output with at least three months of bills and adjust the profile until the two agree.
Frequently asked questions
How much water does one person use in a month?
The calculator's average profile assumes 140 litres per person per day. Over 30 days that is 4.2 m³ per person per month, or 4,200 litres. The economical profile of 80 litres a day gives 2.4 m³, and the high profile of 200 litres a day gives 6.0 m³. These are planning values set by the calculator, not measured figures for Singapore. To see your own household's use, divide the total volume on your PUB bill by the number of residents and by the number of days in the billing period.
What does a monthly use of 29 m³ mean?
29 m³ is 29,000 litres. Divided by 30 days, that is about 967 litres a day. For a household of three people, that is roughly 322 litres per person per day, more than double the average profile used here. The usual causes are a leak, most often in a toilet cistern or a dripping tap, a regularly watered garden or pool, a washing machine that is not working properly, or a household larger than the number entered. Run the leak check described in the explanation first. If the meter keeps moving with all taps and appliances off, contact PUB.
How much does a three-person household pay for water each month?
Using the average profile of 140 litres per person per day, a three-person household uses about 12.6 m³ a month. The amount payable depends on the water rate shown on the bill and on the charges listed there. Enter the rate from your latest bill to get the variable cost. Fixed or separate charges on the bill are not part of the calculation, so add them to the result if you want the full amount. Because rates can change, check your most recent bill whenever you use the calculator, and treat the figure as an estimate.
Where do I find the water rate for my home?
The rate per cubic metre is shown on your water bill issued by PUB, alongside the volume used. If you cannot find it, or the bill is unclear, ask PUB to confirm the rate that applies to your account. Use the rate on its own, since the calculator multiplies only the volume by that rate. Check the effective date of the rate as well, because an old rate will produce an outdated cost.
How much water does a swimming pool use each month?
The calculator adds a fixed 5 m³ per month when a pool is selected. This is a planning allowance for evaporation, splashing and filter backwashing. Actual use depends on pool size, whether the pool is covered, how often it is topped up and the weather. A covered pool that is rarely used will use much less, while an open pool in hot, dry weather can use more. Compare the calculator result with your bills over several months to judge whether the allowance fits your situation.
When should I contact PUB about my water bill?
Contact PUB when the bill rises noticeably without a clear reason, such as a new resident, a new garden or pool, or a long dry spell. Start by checking for leaks: turn off all taps and appliances, note the meter reading, wait 30 minutes and read the meter again. If the reading has moved, there is a leak. PUB can confirm the meter reading and advise on an inspection. If the leak is in the pipework inside the home, a licensed plumber can locate and repair it. Check with PUB which parts of the pipework are your responsibility before arranging any work.
Can I use this calculator for a condominium or a landed house?
Yes. The calculator uses the number of residents, a usage profile and optional garden and pool allowances, which apply equally to a flat, a condominium or a landed house. A landed house with a larger garden is the case most likely to be affected by the garden allowance. Where one meter serves several units and the cost is shared out, the calculator will not give an accurate split. In that case, use the actual meter reading and the billing arrangement that applies to the building.
View all Garden, Outdoor & Water calculators →
By RivoCalc · Reviewed under our editorial methodology · Updated 14 May 2026
This calculator gives an estimate only. Real water use depends on appliances, fittings, household habits and weather, and the amount payable depends on the rate and charges on your own PUB bill. Check your bill for the final figures.
