Lawn Turf and Seed Quantity Calculator
Calculates how many turf rolls or kg of lawn seed a garden needs, including an allowance for cutting waste, with an optional material cost estimate.
For a 40 m² garden with a 10% waste margin, the area to cover is 44 m², which means 44 turf rolls of 1 m² each. If you sow the same 44 m² from seed at 35 g/m², you need 1,540 g, or 1.54 kg, of seed.
Those two figures are the core of this calculator. Turf is sold in pieces with a fixed area, so the number of rolls is always a whole number, rounded up. Seed is sold by weight, so the result is a quantity in kilograms that you can match against the rate printed on the packet. Both methods start from the same place: the area of the garden, multiplied by a margin that allows for cuts around edges, curves and obstacles.
The area of a turf roll is not standard. It depends on the grower and on the cutting equipment used at the turf farm, so check it on the product label or with the supplier before ordering. Some suppliers sell pieces of 0.5 m², while larger projects are often served with wide rolls of 10 m² or more that are laid by machine. The difference matters: 44 m² is 44 rolls of 1 m², but 88 pieces of 0.5 m². Enter the real roll area of the product you plan to buy.
The waste margin covers the offcuts. A simple rectangle beside a straight fence or path loses very little turf, so a 10% margin is usually enough. Gardens with curves, beds to work around, trees or paths cut into the lawn lose more, and a margin of 15 to 20% is more realistic. Overordering is cheaper than a second delivery, but turf should be laid soon after it is cut, so matching the order to the real area avoids both shortages and waste.
Turf or seed depends on how soon you need a lawn and what you want to spend on materials. Turf gives an established lawn within weeks, but its material cost per square metre is higher. Seed is far cheaper in materials, but the lawn takes several weeks to establish. Choose the method, enter the length and width, set the margin and, if you know it, the price per square metre or per kilogram to see an estimated material cost.
Treat the result as a planning figure rather than a final order. Confirm the roll area and the seed rate on the product label, check the soil and local climate before you start, and allow a little extra for patching.
The result updates automatically.
10% for simple rectangular areas. 15–20% for irregular shapes with lots of cutting.
Varies by supplier: check the area stated on the product sheet before buying.
Rolls needed
for 88.0 (1 roll)
- Base area
- 80.0 m²
- Area with allowance
- 88.0 m²
- Rolls (1 each)
- 88 rolls
How it works
Formula
How the calculation works
Lawn turf and seed: how to work out the right quantity
Anyone turning a rough patch of ground into a usable lawn faces the same question: how many turf rolls to order, or how much seed to buy? Ordering too little means another trip to the supplier, and turf from different batches or farms rarely matches exactly in colour or cut. Ordering too much wastes money, and turf has a short window for laying after it is cut, so surplus rolls are hard to keep. A correct calculation at the start saves time and money and avoids a patchy result.
The formula: area plus margin
The starting point is always the area to cover, in square metres. For a rectangular area, multiply the length by the width. For irregular shapes, such as curved beds, rounded edges, or areas to exclude around a shed or tree, the most practical method is to sketch the area on graph paper and count squares, or to split the space into rectangles and add their areas.
The waste margin allows for cutting. Along a straight edge beside a wall or path the loss is small. At corners, curves and access points the offcuts add up. For simple layouts, such as rectangles or L shapes, a margin of 10% is usually enough. For gardens with curves or many obstacles, a margin of 15 to 20% is more realistic. The calculator applies the margin as a percentage on top of the measured area, so the value you enter should reflect how complicated the shape is.
The number of rolls is found by dividing the total area, including the margin, by the area of one roll, then rounding up to the next whole number. Turf is sold in whole pieces, so a result of 44.2 rolls means 45 rolls must be ordered. For seed, the calculator multiplies the total area by 35 g/m², the seeding rate used to establish a new lawn, and divides by 1,000 to give kilograms. Seed packets state their own rate, and that figure should be checked before buying. Heavier rates do not speed up germination. A crowded seedbed produces weak seedlings that compete with each other, so more seed is not automatically better.
What is the area of a roll of turf?
There is no single standard. The area of each roll depends on the grower and the cutting machine used, so it should be confirmed on the product label or with the supplier. The calculator uses 1 m² as its default. Other suppliers sell pieces of 0.5 m², and larger projects can be served with wide rolls of 10 m² or more, laid by machine.
The difference has a direct effect on the number of units. For the same 44 m², that is 44 rolls of 1 m² or 88 pieces of 0.5 m². Before comparing offers, convert everything to price per square metre, and enter the real roll area of the product you intend to buy. Comparing prices per roll without checking the area is a common mistake, because a cheaper roll can cost more per square metre.
Turf or seed?
Turf is the choice for an immediate result. Once laid, watered and rooted, the lawn can be used within a few weeks, which is much faster than seed. Turf is grown on farms and sold through garden centres, nurseries and turf growers, often delivered on pallets. The species mix matters for the climate. Warm-season grasses such as couch (Cynodon dactylon) and buffalo grass (Stenotaphrum secundatum) suit warm and humid regions, and are common in many parts of Queensland and northern New South Wales. Cool-season options such as tall fescue (Festuca arundinacea) and perennial ryegrass (Lolium perenne) are more usual in cooler southern areas. Choose the species with a local nursery or turf grower, who will know which grasses perform in your region and soil. Check the price per square metre at the point of sale and enter it to estimate the material cost before you commit.
For a garden of 80 m² with a 10% margin, 88 m² must be covered, which is 88 rolls of 1 m². Entering the price per square metre from the supplier gives an immediate estimate of the material cost, before any laying begins.
Seed is considerably cheaper in materials, but the lawn takes longer to form. Expect several weeks of germination and establishment before the surface is dense enough to use, and longer in cooler conditions. Quality blends usually combine fine fescues, tall fescue and ryegrass, and are sold in bags at hardware stores and garden centres. For the same 88 m² at 35 g/m², the seed needed is 3.08 kg. The material cost is much lower than the equivalent turf, but the wait is longer and watering must be more careful during establishment.
Common mistakes that cost money
The most frequent mistake is adding no margin at all. One badly measured bed, a tree in the middle of the lawn or a paved path can throw the whole count out.
The second is comparing turf prices per roll without checking the area of each roll. Since formats vary, a cheaper roll can work out more expensive per square metre. The fair comparison is always per square metre.
The third, specific to seed, is applying too much. Germination does not improve when the rate is pushed above the recommended level, and dense seedlings compete with each other and weaken. In practice, use the rate printed on the seed packet for a new sowing, and a lighter rate for overseeding thin or damaged areas. The aim is a balance between good cover and healthy establishment.
Soil preparation: the step that decides success
Whether turf or seed, the result depends largely on the soil. Loosen and decompact the ground to a good depth, level it, and remove stones and roots. On heavy clay or compacted soils, which are common in many newer housing estates, incorporating coarse sand and a layer of good quality topsoil before laying helps drainage and rooting. Turf laid on compacted ground stays shallow-rooted and dries out faster.
Timing matters as well. In most of southern Australia, spring (September to November) and autumn (March to May) are the best periods to lay turf or sow seed, because temperatures are moderate and rainfall reduces the need for watering. Midsummer heat and extended dry spells make new lawns hard to establish without irrigation. In tropical northern areas and hot inland regions, the calendar follows the wet season and access to water instead. Turf should be laid soon after it is cut, because it dries out quickly on a pallet.
When to hire a professional
On flat ground up to about 100 m², laying turf is a job a careful homeowner can handle, provided the soil is well prepared. For larger areas, sloping ground, difficult soils, or gardens with an integrated irrigation system, a landscaper or lawn installer avoids mistakes that are hard to fix later. Labour costs vary with site complexity and region, so get quotes before deciding whether to do the work yourself. Local council rules may apply to changes to drainage, retaining walls or irrigation on some properties, and these should be checked before work starts.
What this calculator does not cover
The calculator assumes a simple area with a single surface. It does not size irrigation, grading or drainage, and it does not allow for turf damaged in transport. For very large or complex sites, check the quantities with a site survey and the supplier's delivery terms before ordering.
Frequently asked questions
How many turf rolls do I need for 100 m²?
For 100 m² with a 10% waste margin, the area to cover is 110 m². With rolls of 1 m², the default in this calculator, that is 110 rolls. If the garden has many curves or obstacles, a 15% margin raises the area to 115 m², or 115 rolls. Because roll sizes vary between suppliers, confirm the area of one roll on the product label or with the supplier, and correct the value in the calculator before ordering.
What is the difference between turf and seed?
Turf is grown lawn that is laid straight onto prepared soil. It gives an established lawn within weeks and is the faster option, but the material cost per square metre is higher. Seed is spread over prepared soil and takes several weeks to germinate and establish, but the material cost is much lower. The right choice depends on how soon you need the lawn and how much you want to spend on materials. Check current prices with your supplier, as they vary by region and season.
What waste margin should I use for an irregular garden?
For simple rectangular areas, 10% is enough. For gardens with curves, rounded edges, or many obstacles such as garden beds, trees and paths, use a margin of 15 to 20%. Waste comes from the cuts needed to fit turf around edges, so the more irregular the shape, the more offcuts and the greater the loss. If in doubt, choose the higher margin, because a short order means a second delivery.
When is the best time to lay turf or sow lawn in Australia?
In most of southern Australia, the best periods are spring, from September to November, and autumn, from March to May. Temperatures are moderate and rainfall reduces the need for watering. Midsummer heat and dry spells make new lawns hard to establish without irrigation. In tropical northern areas and hot inland regions, the timing follows the wet season and access to water instead, so ask a local turf grower or nursery for the right window.
How much turf do I need for 50 m² if the roll size is different?
For a 50 m² garden with a 10% margin, the area to cover is 55 m². With rolls of 1 m², that is 55 rolls. If the supplier sells pieces of 0.5 m², the same area needs 110 pieces. Enter the price per square metre from the supplier to estimate the material cost. Labour is a separate cost if you hire a landscaper, and it varies with the region and the complexity of the site.
When should I hire a professional lawn installer?
For areas up to about 100 m² on flat ground with no irrigation system, a careful homeowner can lay turf without difficulty. For larger areas, sloping ground, heavy clay or compacted soil, gardens with an integrated irrigation system, or heavy soil preparation, a landscaper or lawn installer is the safer choice. The cost of a professional should be weighed against the cost and effort of redoing poorly laid turf.
Related calculators
View all Garden, Outdoor & Water calculators →
By RivoCalc · Reviewed under our editorial methodology · Updated 17 May 2026
This calculator is for information purposes only. Results are estimates based on standard formulas and may vary depending on real-world conditions. Consult a professional before making important decisions.
