Sod and Grass Seed Quantity Calculator
Calculate how many sod rolls or kilograms of grass seed you need for your lawn, with a waste margin and an optional material cost estimate.
For a 40 m² backyard with a 10% waste margin, you need to cover 44 m², which means 44 sod rolls of 1 m² each. If you sow grass seed instead, the same 44 m² needs about 1,540 g (1.54 kg) at the 35 g/m² rate used in this calculator. The result gives the number of rolls or kilograms of seed for any lawn size, with the waste margin already included.
The real figure depends on the product you buy. Sod comes in several roll and slab sizes, and the 1 m² default in this calculator is only a starting point. Check the product sheet for the area of one roll and enter that value if it differs. Ordering the wrong number of units is the most common reason for a second trip to the garden centre. Sod from different deliveries can also vary slightly in shade, so a small surplus is practical for touch-ups.
Irregular gardens need a larger margin. A straight edge against a fence wastes little, but curves, corners, flower beds and paths all add cuts. For rectangular or L-shaped lawns, 10% is usually enough. For lawns with curves or many obstacles, use 15 to 20%. The calculator accepts either value, so you can compare both before you buy. A detached house in Ottawa with a rounded front lawn around a tree, for example, belongs in the higher range.
The choice between sod and seed comes down to timing and budget. Sod gives a usable lawn within weeks of installation, but its material cost per square metre is higher. Seed costs less, yet it takes several weeks to germinate and longer to fill in. Soil preparation matters for both. The sections below explain the calculation, the common mistakes and the timing for Canadian conditions. Whichever method you choose, treat the figures as the starting point for ordering, not a substitute for measuring the site.
The result updates automatically.
Sod gives an immediate lawn but costs more in materials per square metre. Seed is cheaper, but a new lawn takes several weeks to establish.
10% for simple rectangular areas. 15–20% for irregular shapes with lots of cutting.
Varies by supplier: check the area stated on the product sheet before buying.
Sod is sold by the roll or slab at garden centres, nurseries and sod farms, often with pallet delivery. Check the price per square metre at the point of sale before comparing offers.
Rolls needed
for 88.0 (1 roll)
- Base area
- 80.0 m²
- Area with allowance
- 88.0 m²
- Rolls (1 each)
- 88 rolls
How it works
Formula
How the calculation works
Sod and grass seed: how to work out the right quantity
Anyone turning a rough yard into a usable lawn faces the same question: how many rolls of sod to order, or how much seed to buy? Buy too little and a second trip to the garden centre is needed, and sod from different deliveries rarely matches exactly in shade. Buy too much and money is wasted. Sod also has a short installation window, so it should be laid soon after delivery. A correct calculation at the start saves time, money and frustration.
The formula: area plus margin
The starting point is always the area to cover, in square metres. For a rectangular lawn, multiply the length by the width. For irregular shapes, such as gardens with curves, beds to exclude or obstacles to work around, the most practical method is to sketch the area on graph paper and count the squares, or to divide the yard into rectangles and add their areas.
The waste margin accounts for cutting. Along a straight edge beside a wall or fence, the loss is small. At corners, curves and access points, the offcuts add up. For simple rectangular or L-shaped lawns, a margin of 10% is usually enough. For lawns with curves or many obstacles, use 15 to 20%.
The number of rolls is found by dividing the total area, including the margin, by the area of one roll, and rounding up to the next whole roll, because sod is sold in whole units. In the calculator, C is the length, L is the width, m is the waste margin, A_roll is the area of one roll and 35 is the seeding rate in grams per square metre. The seeding rate of 35 g/m² is the fixed value the calculator uses for establishing a new lawn. If the seed label recommends a different rate, multiply the total area by that rate and compare the result with the calculator output.
What area does one roll cover?
There is no single standard. The area of one roll depends on the supplier and on the cutting equipment used at the sod farm, so it should be confirmed on the product sheet or with the seller. The default in this calculator is 1 m² per roll. Some suppliers sell slabs of 0.5 m², and large-format rolls of 10 m² or more are laid with machinery on big sites. Those differences change the number of units considerably. For the same 44 m², there are 44 rolls of 1 m², but 88 slabs of 0.5 m².
Before comparing offers, convert every price to a cost per square metre, and enter the actual roll area of the product you intend to buy, in square metres.
Sod or seed?
Sod suits anyone who wants an immediate result. Once it is installed and watered, it gives an established lawn much sooner than seed. It is sold at garden centres, nurseries and sod farms, sometimes with pallet delivery. Common mixes include tall fescue (Festuca arundinacea) and perennial ryegrass (Lolium perenne), and blends with Kentucky bluegrass are also widely sold. Bermuda grass (Cynodon dactylon) is a warm-season option. Ask the supplier which species suits your region, sun exposure and winter conditions, and check the price per square metre at the point of sale before deciding.
Grass seed costs less in materials, but a new lawn takes several weeks to germinate and longer to fill in. Mixes of fine fescues, tall fescue and perennial ryegrass are sold in bags, from small packs to larger sacks, at large home improvement stores, garden centres and seed suppliers. For 44 m² at 35 g/m², you need 1,540 g (1.54 kg) of seed. The material cost is far lower than for the same area of sod, but the new lawn needs regular watering throughout the establishment period and is more exposed to weeds and bare patches.
Common mistakes
The first mistake is adding no margin at all. A badly measured flower bed, a tree in the middle of the yard or a paved path can throw the count out.
The second is comparing sod prices by the roll without checking the area of each roll. Because formats vary between suppliers, a cheaper roll can cost more per square metre. The fair comparison is always made per square metre.
The third mistake, specific to seed, is sowing too heavily. Sowing above the rate on the seed label does not produce a better lawn, and crowded seedlings can compete with one another. For a new lawn, the calculator uses 35 g/m², and the rate printed on the bag should take precedence if it differs. For overseeding thin patches of an existing lawn, follow the label rate and use the calculator as a guide only.
Soil preparation: the step that decides the result
Whether you lay sod or sow seed, the result depends largely on soil preparation. Loosen and level the soil, then remove stones and roots, so that the grass has a surface it can root into. Compacted ground restricts root growth and drains less well. Ground that has been compacted by building work or heavy traffic may need loosening and a layer of topsoil before the grass goes in. Heavy clay is harder to work, and some gardeners mix coarse sand and good-quality topsoil into the top layer. Finish with a firm, even surface at a level suitable for mowing. Ask a local landscaper what preparation your soil needs.
Timing in Canada
Spring and early autumn are the windows most gardeners choose for sod and seed, because the heat and dry spells of midsummer make a new lawn harder to keep watered. Watering needs are higher in summer, so plan a watering routine before laying anything in the hot months. Frozen ground is difficult to prepare, and planting onto it is not advisable. Timing varies from the milder south to the colder north, so ask a local nursery or landscaper for the right window in your area.
When to call a professional
For a small, level lawn with no irrigation system, a careful homeowner can lay sod or sow seed without much difficulty, provided the soil is well prepared. Larger areas, sloped sites, heavy clay or compacted soil, and yards with an in-ground irrigation system are where a landscaper or lawn contractor avoids mistakes that are hard to fix later. Labour costs vary with the region and the complexity of the site, so get a written quote before deciding between doing the work yourself and hiring a professional. Compare that quote with the material estimate from this calculator, because the two together give the full picture.
Edge cases and limits
A zero or negative length or width does not describe a real lawn, so enter positive measurements only. The calculator does not account for slope, buried obstacles or seed mixes sold with their own coverage figures. For those, use the product label. It is a planning tool for material quantities and does not replace a site survey.
Frequently asked questions
How many sod rolls do I need for 100 m²?
For 100 m² with a 10% waste margin, the area to cover is 110 m². With the default of 1 m² per roll, that is 110 rolls. If the lawn has many curves or obstacles, a 15% margin raises the area to 115 m², or 115 rolls. Because roll sizes vary between suppliers, check the product sheet and enter the actual area of one roll in the calculator.
What is the difference between sod and grass seed?
Sod is grass that has already grown, laid in pieces onto prepared soil, so it gives a usable lawn much sooner than seed. It usually costs more per square metre. Grass seed is spread over prepared soil. It costs less in materials, but it needs several weeks to germinate and establish, and the lawn is more exposed to weeds and bare patches during that time. The right choice depends on how soon you need the lawn and on your budget.
What waste margin should I use for an irregular garden?
For simple rectangular areas, 10% is enough. For lawns with curves, rounded edges or many obstacles such as flower beds, trees and paths, use 15 to 20%. Waste comes from the cuts needed to fit sod to the edges, so the more irregular the shape, the more cutting and the greater the loss. Measure the area carefully and add the margin on top, because a missing margin is the most common reason for running short.
When is the best time to lay sod or sow grass seed in Canada?
Many gardeners prefer spring or early autumn, because the heat and dry spells of midsummer make a new lawn harder to keep watered. Frozen ground is difficult to prepare, so planting windows depend on region and climate. Check with a local nursery, a landscaper or your municipality for the right window in your area.
How much sod or seed do I need for 50 m²?
For 50 m² with a 10% margin, the area to cover is 55 m². With 1 m² rolls, that is 55 rolls. If the supplier sells slabs of 0.5 m², you would need 110 slabs. For seed at 35 g/m², the same 55 m² needs 1,925 g (1.93 kg). The calculator estimates material quantities, while installation labour depends on the region and the complexity of the site.
When should I hire a professional landscaper for a lawn?
For a small, level lawn with no irrigation system, a careful homeowner can lay sod or sow seed without much difficulty if the soil is well prepared. A landscaper or lawn contractor is the safer choice for larger areas, sloped sites, poor or heavily compacted soil, or yards with an in-ground irrigation system. Get a written quote before you decide, and compare it with the material estimate from this calculator.
Related calculators
View all Garden, Outdoor & Water calculators →
By RivoCalc · Reviewed under our editorial methodology · Updated May 17, 2026
These figures are planning estimates. Confirm the area of one roll and the seeding rate on the supplier's product sheet or seed label, and adjust the calculator to match. Real quantities depend on the shape of the lawn, ground levels and how the work is done.
